WaveSlice · Easy 3D slicing, right in your browser

Loading viewer…

Drop an STL anywhere

Bed 230 × 150 × 140 mm · origin at the center · everything runs in your browser

Orange = overhang faces steeper than the threshold · drag to orbit, scroll to zoom

FlashForge Dreamer

Extruder

The firmware applies the left-nozzle offset; coordinates are written unchanged.

Quality

Layer height

First layer

Adaptive layers

Layers thin out, down to the finest layer, where the surface comes close to horizontal, so the stair-steps stay below the quality setting. They never get thicker than the layer height; the extra layers show up in the time estimate.

Finest layer

Quality

Favor the front

Faces looking away from the viewer (the back, +Y) tolerate steps up to three times bigger, so the time goes where it shows.

Line width

Walls

Top layers

Bottom layers

Infill

Infill pattern

Temperatures

Nozzle

°C

Nozzle, first layer

°C

Bed

°C

Wave overhangs

always on

Steep overhangs are printed as slow, constant-flow rings growing from the supported edge, so most models need no supports at all.

Line spacing

Flow

mm³/mm

Speed

mm/s

Fan

Max wave span

Fallback supports

Breakaway columns only where the wave cannot work: floating islands, spans wider than the max wave span and unreachable fragments.

XY gap

Z gap

layers

Load a model first.